Genesis GEN3t, Руководство пользователя, Страница: 89 / 1124

7.2.1 Default network settings
By default, all network interfaces are configured to use DHCP. If no DHCP
response is received within six seconds, the network interfaces will assign
themselves network IP addresses in the range of 169.254.xxx.xxx with a subnet
mask of 255.255.0.0. This is called "Automatic Private IP Addressing" and is
also built into Microsoft Windows
®
.
The default Mainframe password is "genesis" (lowercase, without the double
quotation marks).
7.2.2 Connecting the GEN series directly to a PC
The GEN series can be connected directly to the a PC. At the same time, the
PC can be connected to a corporate network. For this you will need a PC with
two Ethernet NICs (Network Interface Cards.) The one for the GEN series must
be at least 1 Gbit for the best performance. You will require either a Cat5e
Ethernet cable or an optical cable from your PC to the GEN series, depending
on the options installed.
Figure 7.3: Direct connection to PC
Since NIC #1 in the illustration is not on the company network, the PC and the
GEN series cannot automatically obtain network IP addresses from a DHCP
server as they normally would. After the DHCP time
-
out period, both the PC
and Genesis mainframe fall back to Automatic Private IP Addressing.
Therefore, it is not necessary to make any network settings on the GEN series
or the PC.
However, communication is only possible a minute or two after
powering up the GEN series. To avoid the one minute wait, a fixed IP address
and subnet mask may be manually assigned in both the PC and the GEN series.
GEN3t
I3995-3.1 en HBM: public 89