Genesis GEN3t, Руководство пользователя, Страница: 864 / 1124

E.7 Master/Slave synchronization verification procedure
To verify the correct operation of the Master/Slave configuration, proceed as
follows:
Hardware setup
1
Set up two GEN series mainframes, each with at least one recorder card
installed.
2 For GEN5i/GEN7t/GEN16t, make sure each mainframe has a Master/
Slave card installed.
For GEN2i/GEN3i/GEN3t/GEN7i/GEN7tA and GEN17tA the system
synchronization connector can be used.
3 Connect a TTL level, 1 Hertz signal to the top input in the first recorder card
of the master mainframe and to the top input in the first recorder card of the
slave mainframe.
4 Switch on both GEN series mainframes and wait until they have completed
the boot process.
5 Using the fiber optic cable, connect any Master/Slave card's connector of
the master mainframe to Master/Slave card's top connector, labelled
M/S
IN , of the slave mainframes (For GEN2i/GEN3i/GEN3t/GEN7i/GEN7tA and
GEN17tA use the Master/Slave synchronisation connector).
6 Check if both LEDs on both Master/Slave cards are illuminated green. (For
GEN2i/GEN3i/GEN3t/GEN7i/GEN7tA and GEN17tA, check the LEDs near
the Master/Slave synchronisation connector).
Software setup
1
If it is not already active, start Perception.
2 In the start dialog, select New blank experiment .
3 Make sure you are connected to the required mainframes. Use the
Hardware Navigator to do this.
4 In the Settings sheet, go to the General group in the task pane and select
Mainframe . A list of available mainframes is displayed in the settings area.
5 Set the master mainframe operating mode to Master in the Master/
Slave mode column.
6 Set the slave mainframe operating mode to Slave in the Master/
Slave mode column.
7 The slave mainframe will now be synchronized to the master mainframe.
The status palette will show a box with the synchronization status of the
Master/Slave system. This box is labelled
MASTER SLAVE .
GEN3t
864 I3995-3.1 en HBM: public