Genesis GEN3t, Руководство пользователя, Страница: 166 / 1124

11.3.3 Setting the Master/Slave operating modes
Each mainframe can be used as a Master or Slave by using the standard
available Master/Slave synchronization connector. The operating modes are
set up using the Perception software.
In the Perception work area:
Figure 11.7: Perception work area with Master/Slave
A Settings tab
B General group
C Master/Slave mode column
To set the Master/Slave operation in the Perception software, proceed as
follows:
1 Select the Settings sheet.
2 In the Settings sheet, go to the General group in the task pane and select
Mainframe .
A list of available mainframes is displayed in the settings area.
3 Set the master:
a Select the mainframe that should be used as Master.
b
Double
-
click on the Master/Slave mode cell to open it for modification.
c
In the drop
-
down list that appears, select Master .
4 Set one or more slaves:
a Select the mainframe(s) that should be used as Slave.
b
Double
-
click on the Master/Slave mode cell to open it for modification.
c
In the drop
-
down list that appears, select Slave .
To disable the Master/Slave operation and set the mainframe to Stand
-
alone
mode:
GEN3t
166 I3995-3.1 en HBM: public