General 850-3, Руководство пользователя

Страница: 10 / 23

NOTE
This saw is intended for use with 10" (250mm) diameter or less saw blades having a center hole diameter of
5/8". There are many types of blades available to perform specific cutting jobs, such as crosscuts or ripping
only, or tor
use
with plywood, paneling and other products. A good quality specialty blade can produce a finer
finish, be more efficient and place less strain
on
the saw. Use only saw blades designed for
use
at a maxi- mum
operating speed of
6000 RPM
or less. Saw blades should be kept clean and sharp. Never store saw blades
by stacking them directly in contact with each other . Place a layer of cardboard or similar material between
the blades to keep them from coming into contact with each other.
ATTACH THE BACK FENCE RAIL TO YOUR SAW
Referring to the diagram above , place hex . head bolts and where applicable lock washers and nuts to assemble
the rear rail to the back of the saw.
INSTALL AND ALIGN THE FENCE
Proceed to fence installation and alignment as per the instructions provided in your fence manual.
REMOVE / INSTALL A SAW BLADE
Be sure the saw is unplugged and completely disconnected whenever installing or removing a saw blade!
REMOVE A SAW BLADE
◄
LOOSEN
1.
Remove the table insert
.
8
Holding the arbor with the arbor wrench provided,
,
wedge a block of wood between the teeth in front
of the saw and pull the arbor wrench toward you or
counterclockwise
.