Flexi
-
Rooter 100
®
For Adjustable Chain Cutters and ClogChopper Com-
bination (FIGURE 4)
1. Insert the appropriate leader into the ClogChopper until it stops
and tighten the set screws.
2. Slide the chain cutter and leader protector (when applicable) onto
the leader.
3. Slide one end of the chain cutter against the ClogChopper and
tighten the set screws.
4. While keeping the chains from twisting, slide the opposite end of
the chain cutter closer to or further away from the first end in order
to achieve the desired cutting size and tighten the set screws.
5. Ensure that at least 1/2" of shaft is exposed beyond the end of the
chain cutter.
7
FIGURE 3a
FIGURE 3b
FIGURE 4
CHECK THAT THE FLEXIBLE SHAFT COUPLER
SCREWS ARE TIGHT BEFORE EACH USE. USE THE
SUPPLIED LOCTITE
®
ANY TIME SCREWS ARE TIGHT-
ENED ONTO A LEADER. NEVER USE PERMANENT
THREAD LOCKER. SEE MANUFACTURER’S WEBSITE
FOR PROPER USE.
ATTACHING CUTTER/LEADER ASSEMBLIES
(FIGURE 5)
Note:
See the Cutter Application chart to select the appropriate cutter
for the job.
1. Make sure the machine is turned off and unplugged before at-
taching any accessories.
2. If the cutter is attached to a leader, please proceed to the next
step. If not, go to the Attaching Cutters to a Leader section above.
3. Inspect the shaft and leader for damage and make any necessary
repairs. DO NOT use a damaged shaft or leader.
4. Loosen the screws on the leader side of the shaft coupler so that
the leader can be inserted.
5. Insert the leader into the flexible shaft coupler, making sure it
extends to the midpoint of the coupler and tighten the screws to
approximately 41 lb.-in. of torque.
FIGURE 5
For Circular Chain Cutters
1. Insert the appropriate leader into the fitting until it is flush with the
end of the fitting and tighten the set screws.
2. Ensure that at least 1/2" of shaft is exposed.
For ClogChoppers (FIGURES 3a & 3b)
1. Insert the appropriate leader into the ClogChopper until it stops
and tighten the set screws.
2. Ensure that at least 1/2" of shaft is exposed.
