General Dynamics SATCOM Technologies KX 120, Руководство по эксплуатации и техническому обслуживанию

Страница: 16 / 25

600-1152A 7
3.0 RECOMMENDED MAINTENANCE SCHEDULES AND PROCEDURES
3.1 Pedestal/Reflector Assembly Protective Finish
The pedestal/reflector assembly should be inspected at least quarterly and should be
maintained as follows:
Note: The following describes processes and materials to repair finishes typical
to the standard product. In the event of a customer specific finish, please
refer to the accompanying documentation or contact General Dynamics
SATCOM Technologies Customer Service.
a. Remove accumulations of dirt and/or grease using a solution of hot water and
detergent. Follow cleaning with a clear water rinse.
b. Repair damaged or deteriorated surface finishes as follows:
3.1.1 Galvanized Steel, Reflector Back-Up Structure and Pedestal Assembly
Reference the following General Dynamics SATCOM Technologies documents and
procedure when touch-up of surface is necessary:
400-0259 Manufacturing Process Specification (Galvanized Surfaces Only)
450-0072 Paint Requirement (Painted Surfaces Only)
460-0043 Manufacturing Process Specification (Painted Surfaces Only)
a. Clean thoroughly using a solvent for greasy areas; hot water and detergent for dirt
accumulations.
b. Wire brush to remove oxidation.
c. 1. Where the galvanized finish is damaged, apply a coat of cold galvanizing type
paint, aerosol or liquid in accordance with General Dynamics SATCOM Technologies
procedure 400-0259.
2. Where the painted finish is damaged, apply a coat of gloss white per 460-0043.
3.1.2 Reflector Surface Panels (Painted Aluminum)
Reference the following General Dynamics SATCOM Technologies documents and
procedure when touch-up of surface panels is necessary:
450-0009 Paint Requirement (Flat White)
450-0072 Paint Requirement (Primer)
460-0009 Manufacturing Process Specification (For Coating Steel or Aluminum)
460-0043 Manufacturing Process Specification (Priming)
a. Lightly sand damaged area.
b. Clean sanded area to remove any particles left by sanding.
c. Apply one coat of primer.
d. Allow primer to air dry.
e. Apply the first coat of flat white paint.
f. Allow first coat of flat white paint to dry thoroughly.
g. Apply second coat of flat white paint.