General DataComm SpectraComm SDT, Инструкция по установке и эксплуатации

Страница: 5 / 74

076R174-000 SpectraComm SDT iii
Issue 4 Installation and Operation Manual
Preface
Scope of this Manual
This manual describes how to install, configure and operate the SpectraComm Synchronous Data
Transport card. The information contained in this manual has been carefully checked and is
believed to be entirely reliable. This information is intended for installers, service technicians and
users and assumes a working knowledge in the design, planning and management of IP networks.
As General DataComm improves the reliability, function, and design of their products, it is possible
that the information in this document may not be current. Contact General DataComm, your sales
representative or point your browser to
http:\\www.gdc.com for the latest information on
this and other General DataComm products.
General DataComm, Inc.
6 Rubber Avenue
Naugatuck, Connecticut 06770 U.S.A.
Tel: 1 203 729-0271
Toll Free: 1 800 523-1737
Manual Organization
This manual is divided into the following chapters. When using the digital version of this manual,
click on any link (shown in blue text) to jump to that section.
• Chapter 1, Introduction & Specifications
describes the SpectraComm SDT features and options. This chapter contains an overview of
product design, intended use and technical specifications.
• Chapter 2, Installation & Connections
provides directions for installing the SC-SDT in a SpectraComm shelf system or enclosure.
• Chapter 3, SC-SDT Configuration
describes terminal, Telnet, and CLI interfaces used to configure and control the SC-SDT.
• Chapter 4, The Web Interface
describes the web-based (HTTP) interface and web-based CLI used to configure and control
the SC-SDT operation in a SpectraComm shelf.
• Chapter 5, Additional Features
describes the configuration or use of additional SC-SDT features, such as Time Protocols,
Authentication Protocol, Contact Sense, the Telnet Menu, System Message Log
and Alarm Log, SNMP Traps, and Connect/Disconnect Controls.
• Appendix A, Application Guidelines
provides useful information on SC-SDT factory defaults, access modes, the command line
interface and any special application considerations.