General DataComm SpectraComm ADT 16-Port, Руководство по установке и эксплуатации, Страница: 49 / 76

076R172-000 SpectraComm ADT 4-1
Issue 2 Installation and Operation Manual
Chapter 4:
The Web Interface
Introduction to Web Management
In addition to the command line interface at the Craft and Telnet interfaces, SC-ADT provides
access to a web interface through its integral HTTP server. This server allows authorized users to
view and change SC-ADT configuration and operation parameters in a streamlined logical format
via their popular web browsers. This release of the SC-ADT provides the web-based Command
Line Interface.
Web Management Requirements
1. Minimum browser requirements are as follows:
• Netscape Communicator Versions 4.5 through 5.x are supported.
• Internet Explorer 5.0 or higher.
• Cookies must be enabled
Note
At the terminal or craft interface, you can toggle http disable/enable to clear all cookies.
2. Via the Telnet or the Craft interface, SC-ADT must be configured for web management
using the ADMIN commands that:
• enable the http interface.
• configure user accounts by entering names, passwords and
read/write permissions for any authorized users
3. Via the Craft or Telnet interface, SC-ADT must be configured for management with an IP
address and mask in order to satisfy the IP link and SNMP control. This allows a connection to
the SC-ADT web interface via the Ethernet LAN connection.
4. SC-ADT permits up to eight authorized users and supervisors in simultaneous web
management sessions. If eight sessions are in progress, any additional users will be denied
access.