Generac Power Systems MAC MIH400HC, Руководство пользователя

Страница: 25 / 40

Owner’s Manual for Indirect Fired Heater 21
Maintenance
1. Connect red battery cable from starter contactor to
positive (POS or +) battery post.
2. Connect black battery cable to negative (NEG or -)
battery post.
3. Refer to Engine and Heater Startup .
Other Maintenance Checks
The following inspections should be performed by an
authorized service technician, or a properly trained auth-
orized operator. These maintenance items require a high
level of experience and skill to evaluate and correct.
• Inspect engine accessory drive belts.
• Inspect hoses and connections.
• Inspect fuel supply system.
• Inspect exhaust system.
• Inspect exhaust pipe sleeve.
Short Term Storage
When the machine will not be in use for three or more
months, follow the guidelines below to properly store the
machine:
• Perform all necessary maintenance or repairs
based on the
Maintenance Schedule . If neces-
sary maintenance is upcoming, perform the main-
tenance action before storing.
• Fill the fuel tank to FULL.
• Fill coolant to FULL. Do not drain.
• Remove all dirt and debris from inside and outside
the enclosure.
• Lock the machine to prevent any unauthorized
operation.
• Store in a safe location — do not position near or
on top of any combustible materials; observe any
local, state, or national codes or regulations. Store
in a low moisture, low dust area.
• Disconnect the negative cable from the battery.
Return to Service
Follow the guidelines below for engines and machines
that have not been operated for three to six months:
• Conduct a thorough inspection of the machine
before starting the engine.
• Verify the maintenance schedule is up to date.
• Check all fluids for signs of fouling or degradation.
• After starting the engine, let it warm up for more
than 10 minutes at idle.
NOTE: Do not start or operate a machine in need of
repair or maintenance. Perform all maintenance tasks
and repairs before starting. Contact a GMP ASD if there
is any doubt as to the machine’s usability.
(000167)
CAUTION
Do not make battery connections in reverse.
Doing so will result in equipment damage.