Generac Mobile MLG15, Руководство пользователя

Страница: 27 / 36

Owner’s Manual for Mobile Generator 23
Section 5: Troubleshooting
General Troubleshooting
This information is intended to be a check or verification
for simple causes that can be located and fixed. It does
not cover all types of problems. See the engine operator’s manual for additional troubleshooting
information.
Procedures that require in-depth knowledge
or skills should be referred to a trained technician.
General Troubleshooting Guide
Problem
Possible Cause Solution
Low Oil Pressure
Shutdown Low oil level Check oil level on dipstick. Add oil if needed.
Oil leaking from engine Visually inspect the engine for leaks. Restart unit and verify loss of
pressure. Shut down immediately if pressure does not reach 5 psi
(34 kPa) within five seconds.
Oil pressure sender See engine operator’s manual to identify corrective action.
High Coolant
Temperature Shutdown Low coolant level Add coolant if needed. Allow engine to cool, then check coolant
level in radiator. Restart engine and check coolant temperature
(on controller). Stop engine immediately if coolant temperature is
210°F (99°C) or more.
Blockage in radiator Check radiator shroud and ducting for blockage and remove any
foreign matter.
Leakage in coolant hoses,
engine block, or water
pump Inspect for visible leaks. Check tension of water pump serpentine
drive belt.
Remove load on generator and restart engine. Check coolant
temperature and shut engine down immediately if it starts to
overheat (230 degrees or higher). See the engine operator’s
manual for additional information on engine overheating.