HT320BC Data Sheet
Genelec Document BBA0069001a. Copyright Genelec Oy 11.2008. All data subject to change without prior notice
International enquiries:
Genelec, Olvitie 5
FIN-74100, Iisalmi, Finland
Phone +358 17 83881
Fax +358 17 812 267
Email [email protected]
In the U.S. please contact:
Genelec, Inc., 7 Tech Circle
Natick, MA 01760, U.S.A.
Phone +1 508 652 0900
Fax +1 508 652 0909
Email [email protected]
www.genelec.com
In Sweden please contact
Genelec Sverige
Ellipsvägen 10B
P.O. Box 5521, S-141 05 Huddinge
Phone +46 8 449 5220
Fax +46 8 708 7071
Email [email protected]
system specifications
Ht320Bc
Lower cut-off frequency, -3 dB
Upper cut-off frequency, -3 dB
Free field frequency response
of system
≤
33 Hz
≥
20 kHz
35 Hz - 20 kHz (±2.5 dB)
Maximum short term sine wave
acoustic output on axis in half space,
averaged from 100 Hz to 3 kHz
@ 1 m
≥
120 dB SPL
Maximum long term RMS acoustic
output in same conditions with IEC-
weighted noise (limited by driver unit
protection circuit)
@ 1 m
≥
116 dB SPL
Maximum peak acoustic output per
pair with music material
@ 2 m
≥
124 dB
Self generated noise level in free field
@ 2 m on axis
≤
15 dBA
Harmonic distortion at 95 dB SPL at
1m on axis:
freq. 50...100 Hz <1%
freq. >100 Hz <0.5%
Drivers
Bass
Midrange
Treble
All drivers are magnetically shielded
2 x 250 mm (10”) cone
130 mm (5") cone
25 mm (1") metal dome
Weight
Loudspeaker
Amplifier
60 kg (130 lb)
15 kg (33 lb)
Loudspeaker dimensions
Height
Width
Depth*
Amplifier dimensions
Height
Width
Depth*
350 mm (13
3
/
4
”)
950 mm (37
3
/
8
”)
453 mm (17
7
/
8
”)
133 mm (5 1/4”) (3 U)
483 mm (19”)
380 mm (15”)*
* Note that the cable connectors require additional
100 mm (4”) of space behind the loudspeaker cabinet
and the amplifier.
Ht320Bc
Input connector XLR female
pin 1 gnd
pin 2 +
pin 3 -
Input impedance
10 kOhm
Input level for 100 dB SPL
output @1m
variable from +6 to -6 dBu
Input level for maximum short term
output
variable from +26 to +14 dBu for 120 dB SPL @1m
Subsonic filter
18 dB/octave
below 33 Hz
Ultrasonic filter
12 dB/octave above 25 kHz
Crossover frequency
Bass/Mid
Mid/Treble
410 Hz
3 kHz
Crossover acoustical slopes
24 - 32 dB/octave
Crossover level control operating
range in 1 dB steps
Bass
Mid
Treble
from 0 to -6 dB
from 0 to -6 dB
from 0 to -6 dB
Bass roll-off control in 2 dB steps
from 0 to -8 dB @ 33 Hz
Bass tilt control in 2 dB steps
from 0 to -8 dB @ 80 Hz
The 'CAL' position is with all tone controls set to 'off'
and input sensitivity control to maximum.
Ht320Bc
Bass amplifier short term output power
400 W (4 Ohm load))
Midrange amplifier short term output
power with an 8 Ohm load
120 W
Treble amplifier short term output
power with an 8 Ohm load
120 W
Long term output power is limited by driver unit protec-
tion circuitry.
Slew rate
80 V/µs
Amplifier system distortion at nominal
output
THD
SMPTE-IM
CCIF-IM
DIM 100
≤
0.05%
≤
0.05%
≤
0.05%
≤
0.05%
Signal to Noise ratio, referred to full
output
Bass
Midrange
Treble
≥
100 dB
≥
100 dB
≥
100 dB
Mains voltage
100/200V or 115/230V
Voltage operating range
nominal ±10%
Power consumption
Idle
Full output
60 W
500 W
Autostart
Signal sensing Standby/On switching
Remote control
Remote controlled Standby/On switching by 12 V
trigger or external switch
amplifier section
crossover section
In China please contact:
Beijing Genelec Audio Co. Ltd.
Jianwai SOHO, Tower 12, Room 3304
39 East 3rd Ring Road
Chaoyang District
Beijing 100022, China
Phone +86 10 5869 7915, Fax +86 10 5869 7914
