background image

Safety considerations

Although the HT312B and HT315B loudspeak-
ers have been designed in accordance with 
international safety standards, to ensure safe 
operation and to maintain the instrument under 
safe operating conditions, the warnings and 
cautions listed overleaf must be observed:

1.   Servicing and adjustment must only  
 

be performed by qualified service  

 

personnel. The amplifier must not be  

 

opened.

2.   Do not use the loudspeakers with an  
 

unearthed mains cable or unearthed  

 

mains connection as this may lead to  

 

personal injury.

3.  These loudspeakers are capable of  

Figure 7: The curves above show the effect of the ‘bass’, ‘mid’ and 
‘treble’ level controls, and the ‘bass tilt’ and ‘bass roll-off’ controls 
on the free field response of the HT312B, measured at 2 m.

Figure 9: The upper curve group shows the horizontal directivity 
characteristics of the HT312B in its vertical configuration 
measured at 2 m. The lower curve is a 1/6 octave power 
response measurement, derived from 144 individual directivity 
measurements.

Figure 8: The curves above show the effect of the ‘bass’, ‘mid’ and 
‘treble’ level controls, and the ‘bass tilt’ and ‘bass roll-off’ controls 
on the free field response of the HT315B, measured at 2 m.

Figure 10: The upper curve group shows the horizontal directivity 
characteristics of the HT315B in its vertical configuration 
measured at 2 m. The lower curve is a 1/6 octave power 
response measurement, derived from 144 individual directivity 
measurements.

 

producing sound pressure levels in  

 

excess of 85 dB, which may cause  

 

permanent hearing damage.

4.  Free flow of air around the amplifier is  
 

necessary to maintain sufficient cooling.  

 

Do not obstruct airflow around the  

 

amplifier.

5.  To prevent fire or electric shock, do not  
 

expose the unit to water or moisture. Do  

 

not place any objects filled with liquid,  

 

such as vases on or near the  

 

loudspeaker or the amplifier. 

6.   Note that the amplifier is not completely  
 

disconnected from the AC mains  

 

service unless the mains cable  

 

is removed from the amplifier or the  

 

mains outlet.

Guarantee

These products are supplied with two year 
guarantee  against  manufacturing  faults  or 
defects  that  might  alter  their  performance. 
Refer to supplier for full sales and guarantee 
terms.

Содержание HT312B







Отзывы: