Genelec G Two, Быстрая настройка

Страница: 7 / 20

English 7
Figure 1. Control and connector layout on the rear panel of a G Two.
Tabletop
This switch is recommended to be switched to
“ON” when the loudspeakers are placed on a ta-
ble or similar surface, such that there is a reflec-
tive surface between the loudspeaker and the lis-
tener. Such a placement typically causes a boost
at certain bass frequencies, which the “Tabletop”
function is designed to compensate for.
Low Bass
This switch activates a -4 dB filter to the lowest bass
frequencies (65 Hz). This can be used for compen-
sating for heavy and boosted bass in this frequency
range.
LOW BASS -4 dB
LED OFF
LEVEL -10 dB
ISS
TABLETOP
BASS -6 dB
G Two
Active Loudspeaker
ON
OFF
-2 dB
-4 dB
29
2-
80
30
W
WARNING: ELECTRIC SHOCK HAZARD. DO NOT OPEN. DO NOT
SUBJECT TO WATER OR MOISTURE. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
USE EARTHED MAINS CONNECTION ONLY.
AVERTISSEMENT: RISQUE DE CHOC ÉLECTRIQUE. NE PAS
OUVRIR. NE PAS EXPOSER À L'EAU OU L'HUMIDITÉ. AUCUN
COMPOSANT À L'INTÉRIEUR REMPLAÇABLE PAR L'UTILISATEUR.
ADRESSER TOUTE RÉPARATION À UN PERSONNEL QUALIFIÉ.
CET APPAREIL DOIT ÊTRE RACCORDÉ À LA TERRE.
LAITE ON LIITETTÄVÄ SUOJAKOSKETTIMILLA VARUSTETTUUN
PISTORASIAAN.
APPARATET MÅ TILKOPLES JORDET STIKKONTAKT.
APPARATEN SKALL ANSLUTAS TILL JORDAT UTTAG.
MADE IN FINLAND
MAINS INPUT
50 / 60 Hz 60 W
100 - 240 V~
29
2-
G2
BT
www.genelec.com
SERIAL NUMBER
This device complies with FCC Part 15 and Canadian
ICES-003 radio frequency Class B emission requirements.
Refer to operating manual for full information.
RCA INPUT
REFLEX PORT
TONE CONTROLS
CONNECTOR PANEL
(HORIZONTAL)
Iso-Pod™ TABLE
STAND
THREADS FOR
CEILING AND
WALL MOUNTS
POWER SWITCH