Page 7
Page 7
Page 6
Page 6
9.4 - SYSTEM ARMING:
on#password#
When the SMS is sent to the system it will reply:
-System armed; GPS status; latitude; longitude; speed; hour; date.
9.6 - SYSTEM STATUS:
status#password#
When the SMS is sent to the system it will reply:
-System status (armed or disarmed); GPS status; latitude; longitude;
speed; hour; date.
9.5 - SYSTEM DISARMING:
off#password#
When the SMS is sent to the system it will reply:
-System disarmed, GPS status; latitude; longitude; speed; hour; date.
9.7-
:
pas#password#x,y#
x 0
1
y 0
1
pas ok/sleep on
= or (0=OFF; 1=ON) to enable/disable passive arming.
= or (0=OFF; 1=ON) to enable/disable sleep mode.
When the SMS is sent to the system it will reply: (ex.:
, if both
features have been enabled).
The system will automatically arm 2 minutes after ignition is turned OFF and
will go into sleep mode after 24 hours of vehicle inactivity.
SYSTEM PASSIVE ARMING and SLEEP MODE
ATTENTION
The system is factory set with
.
passive arming disabled and sleep mode
enabled
9.10 - PERIODIC POSITION CONTROL:
pos#password#180#
9.8 - VEHICLE SERVICING MODE ACTIVATION:
seron#password#
The system will activate the “valet mode” (for vehicle servicing) and reply
“servicing mode enabled”.
ATTENTION
During servicing, if the system is disarmed, only the position alarm and the
alarm triggered by the auxiliary input (configuration 0 or 2) are active.
If the system is armed and the valet mode is activated auxiliary input
(configuration 1 and 3) will also be active (refer to the installer manual).
9.9 - VEHICLE SERVICING MODE DEACTIVATION:
seroff#password#
The system will deactivate “valet mode” and reply “Servicing mode disabled”.
9.11 - STOP & GO ACTIVATION:
setup#password#basic#main phone number#new
password#emergency phone number#f#
setup#password#basic#main phone number#new
password#emergency phone number#s#
When the SMS is sent to the system it will reply:
Every time ignition is turned “ON”, the user will receive this message:
Every time ignition is turned “OFF”, the user will receive this message:
When the SMS is received, the system replies:
By sending this command, the user will no longer receive a message every
time ignition is turned “ON” or “OFF”.
setup ok with password= new password.
Key On GPS status; latitude; longitude; speed; hour; date.
Key Off, GPS status; latitude; longitude; speed; hour; date.
Setup ok with password= new password.
9.12 - STOP & GO DEACTIVATION:
The last 3 digits “180” indicate the number of minutes after which the system
checks vehicle position (selectable between 1 and 999 minutes).
After the selected period (in this case 180 min.), the tracking unit checks the
vehicle position and, if it turns out to be different from the one previously saved,
it will send an SMS to the registered phone numbers (as in case of an alarm
condition). The message will ONLY be sent if ignition key is “OFF” during the
set period.
If ignition is turned “ON”, the countdown will start again once ignition is turned
“OFF”.
To disable this function, enter: “000” (three zeros).
ATTENTION
The code for requesting vehicle position must always be a 3-digit number.
This f
is ONLY available when the system is armed.
eature
