9.0 - ADDING NEW DEVICES
PAGE 10 - INSTALLER MANUAL
INSTALLER MANUAL - PAGE 11
10.0 - DELETING PROGRAMMED DEVICES
To carry out this operation successfully, you must first make the required electrical
connections (door switch, bonnet switch and positive under key).
To carry out this operation successfully, you must first make the required electrical
connections (door switch, bonnet switch and positive under key).
!
!
The system can
With the alarm system disarmed, open and keep opened the bonnet and the driver door.
!
record a maximum of 11 devices, either electronic keys or TAG CARDS.
To activate the procedure follow the indications reported below.
The system has a delete mode to remove a programmed electronic key or TAG CARD.
o activate the procedure follow the indications reported below
T
.
With the alarm system disarmed, open and keep opened the bonnet and the driver door.
!
!
!
.
Turn ignition key over 4 times: “ON-OFF”-“ON-OFF”-“ON-OFF”-“ON”.
At the fourth rotation, keep ignition key “ON”.
The siren will chirp twice and the turn indicators will flash twice to indicate the learning procedure of
new devices has started
!
The following operations must be carried out within four seconds otherwise the
procedure is invalidated.
Do not close the bonnet otherwise the devices already saved will be deleted as
described in the next paragraph.
!
!
!
!
!
!
!
.
Repeat
other devices.
Turn ignition key to “OFF” and close bonnet and door.
The system is now ready to receive the device codes.
Depending on the device to be recorded, either insert the electronic key into its receptacle or let the
system pick up the TAG signal.
To indicate the new device is learned, the siren chirps once and the status LED blinks once
the above steps to record
When the procedure is completed, the siren chirps once.
!
Storing memory is for 11 devices. If you store an extra one it will automatically delete
the first device recorded in the system memory.
!
!
!
!
!
!
.
.
Close the bonnet; the LED turns on steady.
Turn ignition key over 4 times: “ON-OFF”-“ON-OFF”-“ON-OFF”-“ON”
At the fourth rotation, keep ignition key “ON”
The siren will chirp twice and the turn indicators will flash twice to indicate that the delete procedure
has been initiated.
Keep the bonnet closed for at least 8 seconds until all the devices are cancelled.
The following operations must be carried out within four seconds otherwise the
procedure is invalidated.
The devices will not be deleted if the bonnet is opened before 8 seconds.
!
!
!
!
.
When this procedure is completed, the LED turns off, the siren chirps once and the turn indicators
flash once.
Turn ignition key to “OFF”