INSTALLER MANUAL - PAGE 11
PAGE 10 - INSTALLER MANUAL
10.0 - VEHICLE CODE PROGRAMMING
If the system must work via CAN-BUS line, the alarm system needs to be configured according to the
vehicle on which it is to be installed.
To help you understand the coding procedure, here below is an example illustrating the configuration
procedure. In this case the code used is 1-0-3 which hypothetically corresponds to a “FIAT XXXXX”.
11.0 - SELF-LEARNING OF TURN INDICATORS FLASHES
In order to arm/disarm through the turn indicators, the system must learn the vehicle
locking(arming)/unlocking (disarming) flashes.
Connect the WHITE-ORANGE wire to the turn indicators and then proceed as follows
Disconnect the 8-way wiring connector from the 8-way system connector.
Turn ignition key “ON”.
Connect the 8-way wiring connector to the 8-way system connector; the LED turns on steady.
urn ignition key
lose all doors and press the lock button on the original remote control.
When the turn indicators stop flashing, a high-pitched acoustic signal confirms the learning of the
arming flashes.
Press the unlock button on the original remote control.
When the turn indicators stop flashing, 2 high-pitched audio signals confirm the learning of the
disarming flashes.
This completes the procedure
!
!
!
!
!
!
!
:
T
“OFF”.
C
.
!
!
A separate leaflet, included in the alarm packaging, lists all the available vehicles (codes
are updated at packaging time).
Up-to-date information on supported vehicle models can be found at: www.gemini-
alarm.com (private area).
The system has an indicator LED that signals any wrong vehicle code inserted.
The code must be range between 100 and 235 otherwise the LED on the unit blinks
repeatedly and the procedure is interrupted.
The previously inserted code remains stored.
The procedure is also invalidated if the LED blinks more than 10 times.
In this case there are no optical warnings, the procedure is simply be interrupted.
In either case, repeat the whole procedure.
!
!
Connect the 20-way wiring harness connector to the 20-way system connector.
.
Press and hold the button shown below until the LED lights up
Release the button, the LED switches off.
After 3/4 second pause the LED starts with the first sequence of flashes.
Push the button at firts LED flashing, corresponding to value “1”.
Push
Push
Push
FIRST
FLASH
TENTH
FLASH
THIRD
FLASH
3-4 seconds
After 4 second pause the LED starts with the second sequence of flashes.
Push the button at tenth LED flashing, corresponding to value “0”.
After 4 second pause the LED starts with the third sequence of flashes.
Push the button at third LED flashing, corresponding to value “3”.
Press the vehicle remote control lock/unlock buttons to make sure the alarm system works
properly.
Eventually disconnect the 20-way connector and reconnect it after few seconds.
TEN FLASHES AND
A SHORT PAUSE
THREE FLASHES
ONE FLASH AND A
SHORT PAUSE
When the last digit is entered, the alarm system “repeats” the entered code.
To cancel the programming of the turn indicators reset the system (see
chapter 17.0).
!