This device is warranted against all construction or operating defects for a period of 12
months of the date of manufacture given on the warranty label on the back. If this label is
missing the warranty loses its validity. The manufacturer assumes no responsibility for
anomalies or failures caused by transport or extraneous causes such as electric discharge,
over voltage, mechanical impact, flooding, or due to improper installation or non compliance
with the technical data specified. The alarm has only dissuasive functions against theft.
To replace the battery proceed as follows:
1. Access the programming function (see paragraph 3.1 in the installation manual). In these
conditions, in fact, the control unit does not detect the sabotage alarm caused by the
opening of the sensor.
2. Open the sensor cover by pulling out the cap at the centre of the cover and removing
the fastening screw underneath.
3. Replace the battery and, if desired, check the radio transmission (SYSTEM TEST).
4. Close the cover.
5. Quit the programming function.
TECHNICAL DATA
Power supply
12V alkali battery
Current drained in resting conditions
2µA
Operation with battery charged
ca 1 year
Range of transmitter in free air
20 m
Transmission frequency
433.92 MHz
5000IS-CM - Rev. 00 / 01/ 02
5000CM
5000IS-CM - Rev. 00 / 01/ 02
This device is warranted against all construction or operating defects for a period of 12
months of the date of manufacture given on the warranty label on the back. If this label is
missing the warranty loses its validity. The manufacturer assumes no responsibility for
anomalies or failures caused by transport or extraneous causes such as electric discharge,
over voltage, mechanical impact, flooding, or due to improper installation or non compliance
with the technical data specified. The alarm has only dissuasive functions against theft.
To replace the battery proceed as follows:
1. Access the programming function (see paragraph 3.1 in the installation manual). In these
conditions, in fact, the control unit does not detect the sabotage alarm caused by the
opening of the sensor.
2. Open the sensor cover by pulling out the cap at the centre of the cover and removing
the fastening screw underneath.
3. Replace the battery and, if desired, check the radio transmission (SYSTEM TEST).
4. Close the cover.
5. Quit the programming function.
TECHNICAL DATA
Power supply
12V alkali battery
Current drained in resting conditions
2µA
Operation with battery charged
ca 1 year
Range of transmitter in free air
20 m
Transmission frequency
433.92 MHz
5000CM
