Gema OptiSelect Pro GM04-E, Инструкция по эксплуатации и список запасных частей

Страница: 35 / 46

Rev. 00 01/20
OptiSelect Pro GM04-E Fault clearance

35
Fault clearance
Additional error descriptions are to be found also in the control
unit operating instructions!
Incident Causes Corrective action
H11 (Help code on control
unit) Gun not connected Connect the gun
Gun plug or gun cable defective Contact local Gema
representative
Remote control on powder gun
defective Contact local Gema
representative
Gun LED remains dark,
although the gun is triggered High voltage adjustment is set
too low Increase high voltage
Gun plug or gun cable defective Contact local Gema
representative
LED on gun defective Contact local Gema
representative
Powder does not adhere to
object, although the gun is
triggered and sprays powder High voltage and current
deactivated Check the high voltage and
current setting
High voltage cascade defective Contact local Gema
representative
The objects are not properly
grounded Check the grounding
The gun does not spray
powder, although the control
unit is switched on and the
gun trigger is pressed Compressed air not present Connect the equipment to the
compressed air
Injector or nozzle on the
injector, powder hose or
powder gun clogged Clean the corresponding part
Insert sleeve in the injector is
clogged Clean/replace
Pressure valve in the control
unit defective Replace
Solenoid valve in the control
unit defective Replace
No conveying air:
– Throttle motor defective
– Solenoid valve defective
Contact local Gema
representative
Front plate defective Contact local Gema
representative