Gema OptiFeed 4.0 PP07, Руководство по эксплуатации

Страница: 35 / 86

Rev. 00 12/21
OptiFeed 4.0 (PP07) Start-up
•
35
Start-up
Preparation for start-up
Basic conditions
When starting up the powder pump, the following basic conditions, which
have an influence on the powder transport, must be considered:
–
Correct hose layout
–
Maximum length of the conveying distance
–
Powder preparation and powder quality
–
Corresponding power and compressed air supply (volume and
quality) and signals available
Basic information
The adherence of the following principles leads to a successful start-up of
the powder pump:
–
The suction distance and the conveying distance should be kept as
short as possible.
–
At the suction point, ensure homogeneous fluidization so that no air
pockets (craters) can be formed.
–
When laying the hose, the minimum radius of the hose used must be
complied with.
System parameters
The powder pump is configured by using the system parameters. This
configuration will be saved in the equipment memory. The parameters
can be adjusted and requested manually or by remote interface (CAN).
Entering the system parameters
1. Switch on the powder pump
2. Hold key down for 3 seconds