Gehl R105 (EU), Руководство оператора

Страница: 75 / 118

50950260/AP1216 71
Changing Engine Oil and Filter
1. Run the engine until it is at operating
temperature. Stop the engine. Remove
the rear belly pan.
2. Remove the drain plug.
3. From the engine compartment,
remove the oil filter. Clean the filter
sealing surface.
4. Put clean oil on the new oil filter
gasket. Install the filter and tighten 3/4
of a turn past the point where the gas-
ket contacts the filter head.
5. Reinstall and tighten the drain plug.
6. Remove the oil cap and add the rec-
ommended oil. Refer to the “Lubrication” topic in this chapter for oil specifi-
cations and capacities.
7. Start the engine and let it run for several minutes at low idle. Stop the engine.
Check for leaks at the oil filter, drain plug and remote oil drain hose. Check
the oil level. Add oil if it is not at the top mark on the dipstick.
For a replacement element, refer to the “Replacement Parts” topic (page 63).
Changing Fuel Filter
The engine has a fuel filter located on the left side of the engine. To change it:
1. Shut off the fuel supply by turning the fuel shutoff valve on top of the water
trap.
2. Non-DPF Models: Shut off the return line by turning the valve on the fuel
tank.
3. Remove the fuel filter element.
4. Lubricate new fuel filter element gasket with diesel fuel.
5. Install and tighten the filter element one-half turn past point the where the
gasket contacts the filter head.
6. Turn shutoff valve on water separator to ON.
7. Non-DPF Models: Turn on the fuel supply at the fuel tank.
The engine is self-priming. To remove air before starting, turn the ignition key to
the ON position for 30 seconds.
For a replacement element, refer to the “Replacement Parts” topic (page 63).
Figure 11 Rear Belly Pan