Gehl Dyna-Handler 562, Руководство оператора

Страница: 25 / 72

PRINTED IN U.S.A.
23
907880/AP1298
raised or lowered, extended or retracted, until a new
angle is desired.
Boom Angle Indicator:
Mounted on the left side of
the outer boom. Movement of a bubble shows the
angle of boom elevation relative to the frame ground
surface.
Optional Attachments Joystick:
For other options a
2-position joystick is provided. Moving the joystick to
the right or left for ROTATE or LOWER action (grap-
ple, winch, etc.). Depress the top switch for a sec-
ondary attachment function. Depress the side button
for hydraulic release of the attachment tool from the
carrier.
Quick-Release Carrier System:
The inner boom nose
is equipped with an attachment carrying device. This
provides the operator with a convenient means of uti-
lizing various option attachment tools. Refer to the
OPERATION & ADJUSTMENTS chapter for chang-
ing attachment tools procedure.
Auxiliary Hydraulics:
The Telescopic Handler is
shipped from the factory with standard flow auxiliary
front hydraulic connections. A pair of quick-disconnect
fittings conveniently located at the right side of the
inner boom nose can be used for operating hydraulic
flow attachments.
OTHER OPERATION INDICATORS
The following indicators are for fluid level and opera-
tor rear vision/safety.
Hydraulic Reservoir Oil Level & Fill Cap:
The sight
gauge on the side of the reservoir indicates the level of
the hydraulic oil. The fill cap is accessible by remov-
ing the front cover of the front hood section.
Battery Compartment: The battery electrolyte level
can be checked by removing the front hood cover
Transmission Oil Level: The dipstick can be checked
by removing the front hood cover.
Engine Oil Level: The dipstick is located on the left
side of the mid-section of the main hood.
Coolant Level:
The coolant can be checked and added
through the radiator cap located under the top rear
opening on the main hood.
Backup Alarm: Located inside the rear frame cover, it
produces a loud warning sound whenever the machine
is in reverse.
Side Mirror: This is located on the front outside cor-
ner of the hydraulic tank. It provides the operator with
a rear view on the right hand side and rear area behind
the machine.
WARNING
Use extreme caution when raising or extend-
ing the boom. The Telescopic Handler MUST
be level. Loaded or empty, this machine can
tip if not level.
ALWAYS place the transmission in neutral, set
the park brake and keep the service brake
pedal fully depressed before raising or
extending the boom.
NEVER exceed the specified lifting or extend-
ing capacities of this machine. Serious
machine damage or personal injury may
result. Refer to the load charts in the opera-
tor’s station or this manual.
If a boom circuit hose should break with the
boom up, with or without a load, shut the
machine down following the MANDATORY
SAFETY SHUTDOWN PROCEDURE (Safety
chapter p.10). DO NOT attempt repairs. Call
your GEHL dealer immediately for assistance.
The truss boom and winch attachment tools
should ONLY be used to lift and place loads
when the machine is stationary. DO NOT use
truss boom to transport loads around the job-
site. This can cause the load to swing, result-
ing in either the load dropping or machine
tipover.
NEVER use winch for lifting or moving of per-
sonnel. NEVER exceed the maximum rated
capacity of the winch (3000 lbs/1360 kg) or
exceed the load chart rating for winch appli-
cations.
DO NOT tilt the truss boom back more than
45
o
from horizontal. DO NOT attempt to use
the rotating carriage as a load leveling func-
tion. Always level the frame prior to handling a
load.
Failure to heed could result in death or seri-
Courtesy of CraneMarket.com