gefran TPD32-EV-...-2B, Инструкция по эксплуатации

Страница: 208 / 504

—————— TPD32-EV ——————
208
6.12.1 Analog Ouputs
I/O CONFIG
Analog outputs
Analog output 1
[66] Select output 1
[62] Scale output 1
Analog output 2
[67] Select output 2
[63] Scale output 2
Analog output 3
[68] Select output 3
[64] Scale output 3
Analog output 4
[69] Select output 4
[65] Scale output 4
Parameter description No.
Value
Standard
Configuration
min max
Factory
American
Factory
Standard
Select output 1
66 0 94 Actual speed (8) Actual speed (8)
Scale output 1
62 Float -10.000 +10.000 0.000 0.000
Select output 2
67 0 94 Motor current (16) Motor current (16)
Scale output 2
63 -10.000 +10000 0.000 0.000
Select output 3
68 0 94 Flux current (27) Flux current (27)
*
Scale output 3
64 -10.000 +10000 0.000 0.000
Select output 4
69 0 94 Output voltage (20) Output voltage (20)
*
Scale output 4
65 -10.000 +10000 0.000 0.000
* TBO option card (TBO “B”) has to be installed.
Select output XX Selection of the parameter assigned as a variable to the corresponding analog output.
The following assignments are possible:
OFF
Speed ref 1
1)
Speed ref 2
1)
Ramp ref 1
1)
Ramp ref 2 1)
Ramp ref 1)
Speed ref 1)
Ramp out 1)
Actual speed 1)
T current ref 1 2)
T current ref 2 2)
T current ref 2)
Speed reg out 2)
Motor current 2)
0
1
2
3
4
5
6
7
8
9
10
11
15
16
Output voltage 3)
Analog input 1 4)
Analog input 2 4)
Analog input 3 4)
Flux current 5)
Pad 0 6)
Pad 1 6)
Pad 4 6)
Pad 5 6)
Flux reference 7)
Pad 6 6)
PID output 8)
Out vlt level 3)
Flux current max 5)
20
24
25
26
27
31
32
33
34
35
38
39
79
80
F act spd 1)
F T curr 2)
Speed draw out 9)
Output power 10)
Roll diameter
Act tension ref
Torque current
W reference
Actual comp
Brake current
11)
Field cur ref
12)
Motor Pot Out
81
82
84
88
89
90
91
92
93
94
95
96
11)
Output that monitors the value of the Torque proving parameter.
12)
It indicates the field current reference.
Scale output XX Scaling of the analog output concerned
1)
With a scaling factor of 1 the output supplies 10 V when the reference value or
speed corresponds to the value defined by Speed base value .
2)
With a scaling factor of 1, the analog output = 10V when the reference or current
is 100%.
3)
With a scaling factor of 1 the output supplies 10V when the voltage corresponds