Geemarc Loop Hear LH600, Руководство пользователя

Страница: 9 / 18

8
Telephone Connection:
Plug the supplied telephone cord into the TEL jack . The other end of
the cord should be connected to a telephone convertor adaptor. Push the
plug of the telephone convertor into the telephone wall socket.
Connect the Loop Wire
The unit comes with a 38 meters loop wire. Place the wire on the floor
following the wall edges so that the wire runs around the whole room,
starting and ending at the amplifier. Either tuck the wire under the carpet or
fix to the skirting board or wall using the clips provided. Place the loop wire
in the nail clip and hammer the nail clip to the wall in order to fix the loop wire
position. Have a space of 20cm between each nail clip. Any excess loop
wire can either be cut or tied up. The minimum length of loop wire is
10meters. Insert the two ends of the wire into speaker clip terminals
of the unit. Ensure that only bare wire and not the plastic insulation is
inserted.
Connect the Power Supply
Connect the plug of the supplied power adaptor into the DC jack . Plug
the other end of AC power adaptor into the mains wall socket.
Wall Mounting
To wall mount the LH600, drill two holes and insert two screws 40mm apart.
Leave about 5 mm of the screw projecting from the wall,. Guide the wall
mounting apertures of the wall mount over the screws and slide the wall
mount downwards.
Clip the LH600 unit onto the wall mount using the wall mount hanger found
on the base of the unit.
Caution: Ensure there are no electrical lines, water pipes etc. in the wall
where the holes are drilled
INSTALLATION