Geely EC715 2009, Руководство по ремонту

Страница: 1811 / 2181

11.9.2 Description and Operation
11.9.2.1 Description and Operation
Electric door locks use a solenoid valve within each door lock.
Door locks can only be controlled by combination switch on the
left front inside door handle the driver door switch (remote
control key operation). When using the actuator or cylinder lock
to unlock the driver door, all door locks will be unlocked.
Lock and Unlock
– Turn the key on the driver door lock to unlocking position,
all four locks are unlocked.
–
Turn the key on the driver door lock to locking position, all
four locks are locked.
– Inside unlocking / lock switch (driver door): unlock four
doors; lock four doors.
– The rear compartment lid can be opened by the remote
control or the unlock switch (sedan); Hatchback can be
unlocked by the remote control or unlock switch
(hatchback). At speeds up to 5kph the rear compartment /
hatchback unlocking function is prohibited.
Auto Locking
– Turn the ignition switch to the "ON" position. When the
speed is above 20 km/h, all four doors will automatically
lock. If the speed is more than 20 km/h again, auto-lock will
not react. Only when the ignition switch is turned off or then
any door is unlocked and locked, the automatic locking
feature will be activated.
–
After pressing the remote unlock button 15 s, if none of all
four doors, engine hood, rear compartment lid is opened,
all doors will automatically lock. If the unlock button is
pressed inside the 15 s, it will start 15 s timer again.
Key In Lock Reminder
If the key is inserted in the ignition "OFF"(ACC position will not
be detected) position, the door can not be locked; if the driver
door is open, BCM will send a CAN periodic alarm signal to the
instrument to warn that the key is not removed.
Auto Unlocking
– When the doors are locked, after pulling out the ignition key,
all four doors automatically unlock. When door are not
locked, after pulling out the ignition key, all four door locks
will not respond.
–
After receiving the airbag deployed signal from the CAN (3
or more collision signals are received), four doors will
automatically unlock. This function is not guaranteed in the
following circumstances, such as battery voltage low or the
wiring harness damaged by the collision causing the lack
of door locks motor control power supply.
Super Locking (If Equipped)
Achieve super-Lock function in one the following two ways:
– Press the by remote control "locking" key twice in 300ms.
–
In 3s turn the key in the lock from the "Lock" to "Unlock"
position twice. Flash once to confirm the above two ways.
Note
At this point the door can only be unlocked by the valid
key or remote control.
Super Unlocking (If Equipped)
Dual lock unlocking will change the lock motor from dual locking
to central locking status. Under the dual locking status, there
are ways to unlock the dual locking:
– Driver door metal key unlock dual locking
Turn the driver door metal keys to the unlocked position,
dual locking status will be disabled, the lock motor will be
in central locking status.
–
Remote Control Dual Locking Unlock
Use the remote control to unlock, the dual locking status
disabled. The lock motor will be in central locking status.
Flash twice to confirm.
Body Electric Central Locking 11-327
EC718/EC718RV EC715/EC715RV 10/2009