Swivel Arm Hoist
GEDA STAR 200 STANDARD / GEDA STAR 250 COMFORT
Assembly and Operating Manual
Page 9 of 38
BL107 GB Edition 01.2010
4.3.1 Inspection procedures
GEDA STAR
is in compliance with the EC machinery directive 2006/42/EC. A copy of the
conformity declaration is reproduced in this operating manual.
Tests after each installation
see chapter 14.1
The following tests have already been carried out at the factory:
-
Dynamic test with 1.1 x payload.
-
Electrical tests according to EN 60204
-
Function tests.
Recurrent
inspections:
Inspections before commissioning, reoccurring inspections and intermediate inspections are
to be carried out according to national guidelines.
NOTE
GEDA recommends that you carry out recurring inspections on an annual basis. In case of
increased use (e.g. multi-shift operation), carry out inspections at shorter intervals.
The results of the reoccurring inspection can be recorded in writing in the appendix.
4.3.2 Safety notes for assembly, operation and transport
Before starting work at the place of utilisation, acquaint yourself with the working
environment, e.g. obstacles in the work and traffic area, ground load bearing capacity and
necessary safeguarding of the construction site from public transport.
Only load and transport equipment that has been carefully dismantled, packed and tied
securely.
Always secure the machine against unauthorized use (de-energize)! Do not leave any
operating parts lying around loose at the end of work or during breaks; remove and
secure them under lock and key.
Position the load carefully on the load platform; material that tends to slip or is higher than
the platform or could fall must be secured (think about sudden winds).
Never leave the swivel arm hoist loaded. - Unload first.
Do not stand or work beneath the load platform!
Do not place objects under the load platform.
Evenly position loads on load suspension device, observe max. bearing capacity.
Projecting loads are not allowed.
Check for externally recognisable damage, noises and defects. Immediately report any
changes or malfunctions determined to the company management or its authorized
representatives. If necessary, shutdown and secure machine immediately.
Do not enter the load suspension device!
