GEDA
®
1500 Z / ZP
Page 41 of 114
Rev.: 004
BL 076 GB
Translation of the original operating manual
2011 / 03
7.3
Supplementary safety instructions - set up and
connection/installation
Precautionary measures stipulated by the company for avoiding
fires, explosions, dust, gas, steam and smoke (during welding,
burning and grinding work) must be observed.
Adhere to the stated torques. To do this use a calibrated torque
wrench.
Use appropriate lifting gear when working with heavy parts.
Adhere to the minimum requirements for thoroughfares, travel paths
and emergency exits.
Provide sufficient space for opening doors and covers.
Only carry out welding, burning and grinding work on the machine
after consultation and approval from GEDA.
Observe the reduced load-bearing capacity of the platform during
assembly.
Observe the mast anchor distances and trailing cable guides.
Observe the load capacity of the assembly crane.
Avoid mixing up/incorrectly re-assembling dismantled parts. Label
the parts.
In the event of wind speeds of > (45 km/h), bring the platform down
to the ground and cease operation.
During assembly, never do the following from the platform:
o
Reach or lean into the travel path during ascent/descent
o
Allow parts to project into the travel path during
ascent/descent
o
Stand on the load
o
Exit the platform to climb on to the mast or the building.
Cordon off/mark out the assembly/hazard area.
No one is allowed to stand under the assembly/hazard area.
Safety rails on-site may only be removed once the landing-level
safety gates have been installed.
The hoist may only be operated once all landing-level safety
devices have been fully installed and checked.
