GEDA
®
1500 Z / ZP
Page 40 of 114
Rev.: 004
BL 076 GB
Translation of the original operating manual
2011 / 03
Observe the load bearing capacity of pedestals, ladders and steps.
Look out for steps and objects on the ground when entering /
exiting the platform.
Fall protection must be worn when working at a height > (2.0 m).
The machine may not be used as a step or climbing aid. Only use
tested and stable steps/climbing aids. Keep steps/climbing aids free
of dirt and soiling.
At the end of work or if work is interrupted, the machine must be
turned off at the main switch and secured against unauthorised
switch-on (e.g. with a padlock).
If there is a risk of parts falling onto the platform, the
GEDA protective roof must be used.
7.2
Supplementary safety instructions - transporting the
machine/disposing of the machine
When transporting by lorry, secure the load according to
international transport guidelines. Avoid overloading the lorry. Pack
parts in such a way to prevent damages.
No one is allowed to remain in the area under or on the raised
machine/parts of the machine.
Only raise the machine using the necessary parts and at the
prescribed sling points.
The machine may only be transported/assembled on foundations
with a sufficient bearing capacity.
Ensure there is a stable equilibrium when transporting with forklift
trucks. Secure the machine with appropriate means to prevent
slipping/falling. Only transport at walking pace.
Secure the load accordingly when transporting over steep
inclines/slopes.
Label dismantled parts to prevent any mix-up when reassembling.
