Instructions for Assembly and Use
DC2 ”S“
Electronic control for tubular drives
The DC2 ”S“ is a modern and safe alternative to conventional control gear. For ope-
ning or closing of the door the drive unit is activated through a handtransmitter
(radio control) or through a push-button on the housing.
After pushing of the push-button or the handtransmitter the door is triggered UP or
DOWN.
Technical Data:
Supply voltage
230 V AC 50 Hz
Output
2x relay contact, 5 A / 230 V
1x relay contact, 2 A / 230 V
1x supply Voltage 24V/50mA
Connections
1.5 mm
2
max.,
Ambient-
-20 ˚C to +60 ˚C
temperature
geba GmbH is released of its obligations regarding guarantee and product liability if - without
prior permission - the unit has been modified, or if the installation is improper or not in accordance
with our instruction manual.
The installer has to take care that the EMC-regulations are respected.
GB
The most important characteristics of the DC2 ”S“ are:
➢
Simple operation, programming and assembly.
➢
Water-protected enclosure.
➢
A maximum of safety:
➢
The electronic decoder is separately installed in the protected area
➢
Nearly unlimited data security, even with power failure
➢
Direct connection to safety edge
➢
Rolling code transmitter
➢
High switching capacity for direct control of appliances
24V / 50 mA output for lphoto beam
industrial controls
®
industrial controls
®
Service display
The 4 most likely faults are indicated by the service display lamp by means of a
simple flashing code system as below:
1x flash
safety edge defect
2x flash
limit switch not reached
or defect
3x flash
pre-limit switch defect
steady glow
safety edge activated
