Gearmore XB48, Сборка, эксплуатация, обслуживание и каталог запасных частей., Страница: 22 / 32

MAINTENANCE
20
1. Periodically check and maintain proper gear oil level.
2. Every 8 hours grease (1) "outboard hub", (2) PTO shaft universal joints, (3) PTO shaft
safety shield and (4) PTO telescoping surface.
NOTE: Use only a grade Type II tube grease.
NOTE: Do not grease the slip clutch assembly.
3. Before each use, check to make sure all safety shields are installed and working properly.
4. Check tiller tines for cracks and breaks before every use.
5. Periodically check all nuts and bolts to insure they are tight and secure.
6. Periodically loosen torque spring bolts and allow slip clutch to slip for approximately
two (2) revolutions. Loosen the bolts until the springs lose contact with the flange yoke.
This ensures that the slip clutch is not in a "locked" position.
7. Make sure that the clutch slips.
8. Re-tighten the slip clutch, tighten the torque spring bolts until the nut makes contact with
the flange yoke and further tighten one and a half turns (1
1 /
2
). This is a good starting
point, further adjustments may need to be made based on soil conditions.
NOTE: Do not over or under tighten slip clutch assembly or damage may occur.