Gearmore FM-60, Инструкция по эксплуатации, обслуживанию и ремонту

Страница: 8 / 16

BELT REPLACEMENT
TO REPLACE BELT:
STEP 1 Remove PTO shaft.
STEP 2 Remove top cover.
STEP 3 Loosen nut on adjustment pulley to allow for movement.
(See Figure D)
STEP 4 Loosen nut on right side of “L” bracket. (See Figure D)
STEP 5 Loosen belt by moving adjustment pulley in opposite direction you
would to tighten belt.
STEP 6 Remove belt from all pulleys and idlers, leaving it on the main pulley.
(See Figure E)
STEP 7 Loosen nuts (4) retaining the gearbox to the gearbox plate.
Note: the top of the nuts should be flush with the end of the bolts.
STEP 8 Remove bolts (4) holding the gearbox plate to the finishing mower deck.
STEP 9 Remove the gearbox and gearbox plate assembly from the finishing
mower. Note: the belt should be removed with the assembly.
STEP 10 Turn gearbox and plate assembly over and allow to rest on the gear
box. This will allow a space to develop between the main pulley and
the gearbox plate flange. The belt can be removed through this space.
STEP 11 Install new belt.
STEP 12 Reassemble by reversing steps 1 through 10.
After mounting the Finishing Mower to the tractor’s three point lifting system,
set the mower to the desired cutting height. Adjust height by arranging the different
spacers on the four wheels, see page 7, reference #1. This will result in relieving
the weight of the mower from the tractor’s lifting system. There are three height
positions for the chain adjustment. Select the height that allows the mower to float
freely over any terrain without any weight on the three (3) point lift system, see
reference 25, page 8. The Finishing Mower is not designed to cut foreign objects
such as steel rods, old tires or tubes, or tree limbs, etc. It is designed to cut grass
only.
Page 6