GEA T.VIS M-15, Инструкция по эксплуатации

Страница: 79 / 120

Fig.47
Carry out the following steps:
1.
Release the locking screw (2).
2. Turn the adjusting screw (1) of sensor S2 until light-emitting diode B at the
interface module lights up yellow.
3.
Move the sensor with the adjusting screw (1) in the direction of the lower
switching edge (4) of the switching range (3) until LED B flashes yellow.
Setting the switchpoint
Carry out the following steps:
1. Moving the switchpoint upwards
®
All a/m valves/sprayers except for VESTA valves: 1 turn in clockwise
direction
®
VESTA valves: 0.5 turns in clockwise direction
®
Light-emitting diode B at the interface module lights up yellow.
2. Tighten the locking screw (2), torque 1 Nm (0.7 lbft).
3.
Cancel the actuation of solenoid valve Y1.
®
The valve disk moves into the non-actuated position. Light-emitting diode
B yellow goes out and light-emitting diode A lights up green.
4.
Check the feedback function by actuating the valve.
®
The end position of the valve disk has been adjusted.
7.5.2 T-smart Butterfly Valves
This chapter describes the adjustment of the sensor for the following valves:
– Butterfly valves T-smart 7 and 8000
– Mixproof butterfly valves T-smart 9
Start-up
Adjusting the Sensor in the Control Top
430BAL010697EN_2
15.04.2020 79