GEA Omni, Инструкция по эксплуатации

Страница: 75 / 238

Compressor Motor Start outputs may not be switched into manual mode, but they may be pulsed using the but-
ton next to the channel. When the button is touched, the warning shown to the right will appear in the upper right
hand corner, which will warn the user to verify that the motor is uncoupled from the compressor before the
starter is pulsed. Touching the button next to the notification will then energize the motor starter for two seconds.
fig.77: Sample analog input slice display
The above image displays the detailed view of an analog input slice. Each channel that is configured to receive
an input signal will display its name to the side of the image. Unassigned channels will be blank. The current
value read at each input will be displayed below the name of the channel.
fig.78: Sample analog output slice display
The above image displays the detailed view of an analog output slice. Each channel that is configured to trans-
mit an output signal will display its name to the side of the image. Unassigned channels will be blank. Output
may be controlled automatically through the program or manually by a user with service level or higher permis-
sions using the drop down list displayed below the name of the channel. The options in the drop down list
include Auto and manual output values measured in mA. The manual values range from 0 mA to 20 mA in incre-
ments of 4 mA.
Instruction Manual | GEA Omni™
Control panel User interface
Service
GEA Refrigeration North America, Inc. | E_806550_2 | Generated 12.01.2016 75