GEA Omni, Инструкция по эксплуатации

Страница: 211 / 238

Shutdown Explanation
Suction Check Valve Failed To
Close This annunciation will be triggered if, after receiving an instruction to close,
the suction check valve has not indicated that it is fully closed within the
period of time defined by the
Suction Check Failed To Open Shutdown Delay
parameter.
High Motor Drive End Bearing
Temperature This annunciation will be triggered if the temperature measured at the drive
end motor bearing rises above the value of the
High Motor Bearing Shut-
down parameter.
High Motor Non Drive End
Bearing Temperature This annunciation will be triggered if the temperature measured at the non-
drive end motor bearing rises above the value of the
High Motor Bearing
Shutdown parameter.
High Motor Phase A Winding
Temperature This annunciation will be triggered if the Phase A motor winding temperature
rises above the value of the
High Motor Winding Shutdown parameter.
High Motor Phase B Winding
Temperature This annunciation will be triggered if the Phase B motor winding temperature
rises above the value of the
High Motor Winding Shutdown parameter.
High Motor Phase C Winding
Temperature This annunciation will be triggered if the Phase C motor winding temperature
rises above the value of the
High Motor Winding Shutdown parameter.
High Compressor Male Drive
End Bearing Temperature This annunciation will be triggered if the temperature measured at the drive
end of the male compressor rotor rises above the value of the
High Male
Rotor Temperature Shutdown parameter.
High Compressor Male Non
Drive End Bearing Temperature This annunciation will be triggered if the temperature measured at the non-
drive end of the male compressor rotor rises above the value of the
High
Male Rotor Temperature Shutdown parameter.
High Compressor Female Drive
End Bearing Temperature This annunciation will be triggered if the temperature measured at the drive
end of the female compressor rotor rises above the value of the
High Female
Rotor Temperature Shutdown parameter
High Compressor Female Non
Drive End Bearing Temperature This annunciation will be triggered if the temperature measured at the non-
drive end of the female compressor rotor rises above the value of the
High
Female Rotor Temperature Shutdown parameter.
Maximum Male Rotor Position This annunciation will be triggered if the current position of the male com-
pressor rotor has exceeded the value of the
Male Rotor Maximum Shutdown
Position parameter.
Minimum Male Rotor Position This annunciation will be triggered if the current position of the male com-
pressor rotor has fallen below the value of the
Male Rotor Minimum Shut-
down Position parameter.
Instruction Manual | GEA Omni™
Control panel Annunciations
Shutdowns
GEA Refrigeration North America, Inc. | E_806550_2 | Generated 12.01.2016 211