GEA Niro Soavi One7TS, Инструкция по эксплуатации

Страница: 218 / 294

Instructions for use and maintenance
This manual is owned by GEA Niro Soavi Any reproduction, even partial, is prohibited.
10C100-1C0
GEA Niro Soavi 216
10.1 Recommended spare parts
In order to limit the number of shutdowns during production, and the time required for maintenance
and restoration of the machine functions, it is advisable to stock a set of spare parts to replace
elements that are normally subject to wear.
However, the number of spare parts will depend on the production needs and on how important it is
to avoid long shutdowns due to the unavailability of the spare parts.
In specific, in case of homogenizing valves, the replacement at the due time allows the keeping of
the homogenization efficiency and consequently the quality of the treated product.
GEA Niro Soavi
cannot guarantee that a given spare part will be in stock either at their central
warehouse or at Dealers’ due to problems with material availability or the special requirement for
dispatch.
Therefore, shipping is not guarantee of successful delivery and that delays may occur due to customs
problems or loss.
In any case,
GEA Niro Soavi
shall not be responsible for delays arising from the shipping of the
spare parts.
The following is a list of spare parts which, in our experience, is important to have in stock:
• a complete set of gaskets, two sets in case of VHP high-pressure compression heads;
• two sets of packing, including packing washers and anti-extrusion rings
• one or two pumping pistons, if ceramic plungers are used;
• a homogenizing valve set for each stage (for homogenizers);
• a set of balls and valve seats, for VHP high-pressure heads;
• a set of seats and pumping valves, of the machine is used with abrasive products;
• a set of pumping valve springs;
• a pressure gauge for the head;
• seat and ball for safety valve;
• oil filters;
• a set of guide piston gaskets;
• crankshaft oil seal.