GEA Fit R-300, Руководство по эксплуатации и инструкции по установке, Страница: 108 / 168

Programming
Motor capacity (HP) fine tuning
2005-9015-009
01. August 2018
108 / 168
7.5 Motor capacity (HP) fine tuning
Warning!
Risk of injury!
Improper setting of the ”MOTOR CAPACITY” parameter impairs the
control panel to acknowledge properly a motor capacity increase
caused by an obstacle. Set this parameter accurately.
Attention!
Setting the ”MOTOR CAPACITY” beyond the value indicated by the
manufacturer causes heating, overload and damages to the motor.
Note!
The fine tuning steps must be performed under normal operating
conditions.
IVR PRO
● Start the control panel by pressing for 2 seconds the ”START/RESET” button. Observe the
HP reading on the DEMIO UCC100 until the cleaning cycle is completed;
● Read the ”MOTOR CAPACITY HP” by accessing the real time reading
parameter.
● Press key until (rtr) appears;
key
● Press key to select;
● Press keys until (F02) appears;
● Press key to select;
● Note the highest reading and add 0.15 to the reading;
● Stop the control panel by pressing the emergency stop button;
● Press key until (ParA) appears;
● Press key to select;
● Press key until (P04) appears;
● Press key to select;
● Press keys to enter the motor capacity (HP) to the value obtained. Hold the
button for fast change.
IVR PRO Max@ccess
● Press ”INSTANT START” and observe the ”TOTAL HP” reading on the screen until the
cleaning cycle is completed. Note the highest reading and add 0.15 to the reading;
● Press ”SYSTEM”;
● Press ”MOTOR SETTINGS”;
● Use the keypad arrows to select the parameter;
● Use the keypad to enter the motor capacity (HP) to the value obtained.