maintenance
Safety Instructions
7159-9001-108
01. February 2020
8
maintenance
If necessary, please contact your nearest dealer.
8.1
Special Personnel Qualifications
Maintenance work may only be performed by specially qualified personnel in
accordance with the safety instructions.
● Participation in corresponding product training is necessary.
See also the section on ”Personnel qualification”.
8.2
Safety Instructions
To avoid damage to property and/or life-threatening injury to people during
maintenance, the following points must always be observed:
● Only use original spare parts / original wearing parts / original accessories.
In the case of products by other manufacturers it cannot be ensured that they
have been designed and produced from the point of view of loads and safety.
● Whenever any unavoidable work is carried out on live components (e.g.: testing
to locate a fault), a second person must be present who can
disconnect/interrupt the power supply in the event of an emergency.
● The maintenance work specified in the instructions (adjustment, cleaning,
lubrication, inspection, etc.) must be performed at the times specified.
● Observe the specific information for individual components in this manual as
well.
● All warnings and warning signs must be present and legible.
● Immediately replace any components that are not in perfect condition.
● Read the ”Safety” section as well.
Before carrying out maintenance work, make sure of the following:
● the area for the maintenance work and access to the working area has been
secured over a wide area and there should not be any unauthorized people in
the working area;
● Before performing any work on electrical installations or equipment
(components, housing, etc.) switch off all sources of voltage and make sure they
cannot be switched back on again. Put up a sign warning against switching them
back on again.
● disconnect all pressure units from the pressure source and make sure they
cannot be switched back on again unintentionally
