1
DEH-159 Installation Instructions R02
WavePro ™ Power Circuit Breakers
Key Lock Mounting Accessory Kit for
Substructure Cat. No’s WPS50SUBDP1
and WPS50SUBDP2.
Fig. 1
WPSKLMTG3:
Item Qty Description
1
1
Slide Assembly
2
7
Tamper-resistant Screws (1/4-20 x .625)
3
5
Flat Washer
4
1
Pivot Bar Assembly
5
9
Lock Washer
6
2
Tamper-resistant Screws (1/4-20 x .500)
7
1
Shim
KIT CONTENTS (Cat. No. WPSKLMTG3)
This kit shown above contains the slide assembly,
pivot bar assembly, and mounting hardware. This
unit installs on the left side of the substructure. Key
lock is furnished by the customer. See back of this
sheet for lock required. Installation requires 5/32”
tamper-resistant hex wrench.
INSTRUCTIONS
1.
Remove parts as shown in Fig. 1.
2.
Assemble the customer supplied key lock to the
mounting plate using 2 tamper-resistant screws,
lock washers, and flat washers as shown in Fig.
2. Torque screws to 7-9 Ft-Lbs.
3.
Attach key lock and plate assembly to the left
side of the substructure using 2 tamper-
resistant screws and lock washers as shown in
Fig. 2. Torque screws to 7-9 Ft-Lbs.
4.
Mount slide assembly item #1 to left side of
substructure reusing 3 taptites and installing
tamper resistant screws and lock washers as
shown in Fig. 2. (Leave hardware loose.)
5.
If needed, adjust fixed cam as shown in Fig. 3.
Screws may need to be loosened and roll pin
removed in order to make adjustment. Torque
hardware to 7-9 Ft-Lbs. Drill 0.1875 diameter
hole through the fixed cam and side frame.
Reuse and install roll pin.
6.
Insert pivot bar rivet into slide assembly slot and
mount to left side of substructure using shim, 2
tamper resistant screws, lock washers, flat
washers, and reusing 1 taptite with flat washer
as shown in Fig. 2. (Leave hardware loose.)
7.
Move and hold slide assembly back.
8.
Extend key lock bolt.
9.
Release slide assembly and allow it to return.
10.
Torque hardware to 7-9 Ft-Lbs.
11.
Retract key lock bolt.
12.
After assembly, assure slide assembly moves
freely.
CAUTION
: To avoid electrical hazard, make sure
primary and secondary circuits are not energized
while working in the compartment.
