GE Vivid S60N, Базовое руководство по обслуживанию

Страница: 342 / 478

D
IRECTION
FR091521, R
EVISION
1 V
IVID
S60N/V
IVID
S70N B
ASIC
S
ERVICE
M
ANUAL
8-112 Section 8-5 - Electronic Cage Components - Replacement Procedures
P R E L I M I N A R Y
8-5-11 CFE (cFront End) Board Replacement Procedure
NOTE: After physical replacement of the CFE Board, it is mandatory to first reinstall the Vivid™ S60 or Vivid™
S70 software application. Follow the instructions commencing in
step 11 on page 8-180 .
8-5-11-1 Tools
Appropriate Phillips screwdriver.
8-5-11-2 Time Required
15 minutes
8-5-11-3 Preparation
Shut down the Vivid™ S60/Vivid™ S70 ultrasound unit, as described in Power Shut Down on page 4 - 7 .
NOTE: When replacing the CFE Board, it is necessary to remove the four TRX32 Boards from the defective
CFE Board and install them in the replacement CFE Board. This is described in the procedure steps.
8-5-11-4 CFE Board Removal Procedure
1) Remove the following covers: left side, right side, DVD, front .
2) Open and remove the Front End door assembly and place it on a stable surface:
3.) Remove the FEPS:
4.) Disconnect the ECG-to-CFE board cable - see Figure 8-130 on page 8-107 .
CAUTION
When performing these procedures, take precautions to avoid damage of
electrostatic-sensitive components. Always have the ESD wrist strap
connected either to the DIB chassis or to the GND plug at the rear of the
scanner, and to your hand.
If a battery is present, first remove the battery as it contains stored energy.
Refer to
Battery Removal Procedure on page 8 - 145 .
FRU Part #
Refer to
Table 9-15
on page 9-14
.
• Air Inlet (Left Side) Cover Removal Procedure on page 8 - 7
• Right Side Cover Removal Procedure on page 8 - 10
• DVD Cover Removal Procedure on page 8 - 11
• Front Cover Removal Procedure on page 8 - 16
• Opening and Removing the Front End Door Assembly on page 8 - 83
• Front End Power Supply Removal Procedure on page 8 - 109