GE Vivid E9, Руководство по обслуживанию

Страница: 630 / 802

GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
8 - 296 Section 8-13 - I/O Modules replacement
8-13-1-1 Preparations (cont’d)
4.) Remove Left Side cover.
5.) Remove the
BEP Cover .
a.) Loosen the BEP Cover’s fixing screw(s).
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
b.) Tilt the top of the BEP Cover away from the BEP .
c.) Set the BEP Cover aside.
6.) BEP6 Only: Remove the BEP6 Power Board Assembly.
8-13-1-2 Patient I/O module removal procedure
Follow these steps to remove the Patient I/O module:
1.) Inside the BEP there is an opening for the Power and USB cables to the Patient I/O module.
Disconnect the Power cable connector and the USB cable connector from the Patient I/O module.
2.) Remove one screw inside the BEP.
3.) Remove the two fastening screws on the Patient I/O module’s mounting bracket.
4.) Pull the Patient I/O module sideways, out of the frame.
8-13-1-3 Patient I/O installation procedure
Follow these steps to install the Patient I/O:
1.) Align the Patient I/O with the opening and push it into its final position.
2.) Connect the Power and USB cables (inside the BEP).
3.) BEP5 only : Install one screw inside the BEP.
4.) Install two fastening screws on the mounting bracket.
5.)
BEP6 Only : Install the BEP6 Power Board Assembly.
Figure 8-248 Power and USB connectors (rear side of Patient I/O)
POWER
CONNECTOR
USB2 SIGNAL
CONNECTOR