GE Vivid E9, Руководство по обслуживанию

Страница: 615 / 802

GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
Chapter 8 - Replacement procedures 8 - 281
8-11-8 SATA Jumper replacement
The SATA Jumper connects CN DV11 to CN DV12 in 2D systems wilhout DVR.
The jumper is included in the BEP6.X Cable Kit - Spare Part , Part number 5433408-80.
8-11-8-1 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the VIVID E9.
2.) Disconnect the
Mains Power Cable from the wall outlet.
3.) Disconnect all probes.
4.) Remove the
Left Side Cover .
5.) Remove the BEP Cover .
a.) Loosen the BEP Cover’s fixing screw(s).
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
b.) Tilt the top of the BEP Cover away from the BEP .
c.) Set the BEP Cover aside.
6.)
8-11-8-2 SATA Jumper removal
Disconnect the SATA Jumper from the connectors CN DV11 and CN DV12 on the motherboard.
8-11-8-3 SATA Jumper installation
1.) Install the SATA Jumper in the connectors CN DV11 and CN DV12 on the motherboard.
2.) Install the BEP Cover .
3.) Install the Left Side Cover .