GE Solar 7000, Руководство по обслуживанию

Страница: 90 / 214

TROUBLESHOOTING: Introduction
4-4 Solar 7000/8000/View Patient Monitor Revision J
414993-001
Terms Used The terms listed below are used in this chapter. Understanding the
function of each term will help you understand the internal workings of
the monitor.
Abort This is a menu selection that may appear on the monitor during software
downloads from the monitor SERVICE MODE menu. ABORT causes the
download to stop by pushing the Trim Knob control.
Boot Loader The BOOT LOADER is used to download software as a means to receive
system status messages. Entering the BOOT LOADER does not erase
any memory, but downloading new software will erase protected memory.
To activate the BOOT LOADER, perform the following.
• Hold down the NBP GO/STOP and ZERO ALL keys on the front
panel. (For the SolarView remote display controller, hold down the
two blank keys.)
• Press and release the Trim Knob control.
• Keep holding the NBP GO/STOP and ZERO ALL keys (or two blank
keys for the SolarView remote display controller) until the BOOT
LOADER menu appears on the display.
Cold Start A COLD START is used only in extreme circumstances, because it erases
the protected memory and automatically discharges the patient.
• Hold down the NBP GO/STOP and ZERO ALL keys on the front
panel. (For the SolarView remote display controller, hold down the
two blank keys.)
• Press the Trim Knob control.
• Simultaneously release the Trim Knob control, NBP GO/STOP and
ZERO ALL keys.
• Quickly hold down the DISPLAY ON/OFF key until the MAIN menu
appears on the display.
You can verify if a coldstart was initiated in the Run Time Error Log
information window, Error Code:
At the monitor, execute the following menu sequence, starting from the
MAIN menu:
MONITOR SETUP
SERVICE MODE
Password
Enter day and month from monitor screen with leading zeros.
(July 4 = 0407)
REVIEW ERRORS
Select the VIEW SCOPE ERRORS option to open the Run Time Error
Log information window.