30
49-85211-2
Problem
Possible Cause
What To Do
Oven light does not
work
Light bulb is loose or defective.
Tighten or replace bulb.
Pad operating light is broken.
Call for service.
Oven will not
self-clean
The temperature is too high to set a
self-clean operation.
Allow the oven to cool and reset the controls.
Oven controls improperly set.
See the Cleaning the Oven section.
Excessive smoking
during clean cycle
Excessive soil or grease..
Press the
Cancel/Off
pad. Open the windows to rid
the room of smoke. Wait until the
LOCKED
light goes
off. Wipe up the excess soil and reset the clean cycle.
Excessive smoking
during broiling
Food too close to burner element.
Lower the rack position of the food.
Oven door will not
open after a clean
cycle
Oven too hot.
Allow the oven to cool below locking temperature.
Oven not clean after
a clean cycle
Oven controls improperly set.
See the Cleaning the Oven section.
Oven was heavily soiled.
Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
"DOOR ” flashes in
the display
The self-clean cycle has been selected
but the door is not closed.
Close the oven door.
LOCKED light is on
when you want to
cook
The oven door is locked because
the temperature inside the oven
has not dropped below the locking
temperature.
Press the
Cancel/Off
pad. Allow the oven to cool.
“F— and a number
or letter” flash in
the display
You have a function error code.
Press the
Cancel/Off
pad. Allow the oven to cool for one
hour. Put the oven back into operation.
If the function code repeats.
Disconnect all power to the oven for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
Display goes blank
A fuse in your home may be blown or the
circuit breaker tripped.
Replace the fuse or reset the circuit breaker.
The clock is turned off.
See the Special features
section.
Oven is in Sabbath Mode.
Verify that the oven is not in Sabbath Mode.
See the Special Features section.
Power outage,
clock flashes
Power outage or surge
Reset the clock. If the oven was in use, you must
reset it by pressing the
Cancel/Off
pad, setting the
clock and resetting any cooking function.
“Burning” or “oily”
odor emitting from
the vent
This is normal in a
new oven and will
disappear in time.
To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Cleaning the Oven
section. This is temporary.
Strong odor
An odor from the oven insulation is
normal for the first few times the oven
is used.
This is temporary and will go away after several uses
or a self-clean cycle.
My oven door glass
appears to be
"tinted" or have a
"rainbow" color. Is
this defective?
No. The inner oven glass is coated with
a heat barrier to reflect the heat back
into the oven to prevent heat loss and
keep the outer door cool while baking.
This is normal. Under certain light or angles, you may
see this tint or rainbow color.
“Shut Door” flashes
in the display
The oven door has been left open.
Close door and normal mode will resume
Cooking mode
shuts off when
door left open
Door left open after “Shut Door”
flashed in display.
Close door and normal mode will resume
Troubleshooting tips ...
Before you call for service
TR
OUBLESHOO
TING TIPS