4.7.2.2
Setting an IP Address
The QuickPanel
+
Operator Interface provides two methods to set an IP address:
•
DHCP (Dynamic Host Configuration Protocol)
The network server assigns an IP address during QuickPanel
+
initialization. (You
must be connected to the network.) There must be a DHCP server on the connected
network for a valid IP address to be assigned. Contact your network administrator to
ensure correct DHCP server configuration.
•
Manual Method
Specify the numeric addresses obtained from your network administrator for the
QuickPanel
+
IP Address, Subnet Mask and Default Gateway (if applicable).
Note
Run the
to save the settings.
4.7.3
Serial Port
4.7.3.1
IC755CxW07CDx Serial Port Details
•
A terminal block is supplied.
•
The mating terminal block supports stranded 30-14 AWG (0.05 – 2.00 mm
2
) wires.
•
At a minimum, the cable must be rated for 75°C (167 °F) or more.
•
Secure the serial cable to the mating connector while noting signal orientation and
tighten the screw clamps.
•
The torque for the attaching screws is 0.3 Nm (2.66 in-lb).
Interface: x1 RS-232
Connectors: Euro Terminal (Tyco Electronics 284539-5)
Mating Connector: (Tyco Electronics 284510-5)
COM1 Pin Details
Pin #
Signal Name
Pin-out
1
TXD
5
1
2
RXD
3
RTS
4
CTS
5
SGND
40
GFK-2847F
Qui Operator Interface User Manual
For public disclosure
Содержание QuickPanel+
