34
Care and cleaning of the range.
Consumer Support
Tr
oubleshooting T
ips
Care and Cleaning
Operating Instructions
Safety Instructions
Oven Light Replacement
(on some models)
Be sure to let the light cover and bulb
cool completely.
To remove the cover:
Hold a hand under the cover so
it doesn’t fall when released. With
fingers of the same hand, firmly
push back the wire cover holder.
Lift off the cover.
Do not remove any screws to remove the cover.
Replace bulb with a 40-watt
appliance bulb.
To replace the cover:
Place it into groove of the light
receptacle. Pull wire forward to
the center of the cover until it snaps
into place.
Connect electrical power to the
range.
Wire cover holder
Oven Light Replacement
(on some models)
WARNING
SHOCK OR BURN
HAZARD: Before replacing oven light bulb,
disconnect the electrical power to the
range at the main fuse or circuit breaker
panel. Failure to do so may result in
electric shock or burn.
CAUTION
BURN HAZARD:
The glass cover and bulb should be
removed when cool.Touching hot glass
with bare hands or a damp cloth can
cause burns.
To remove:
Turn the glass cover
counterclockwise 1/4 turn until
the tabs of the glass cover clear the
grooves of the socket. Wearing latex
gloves may offer a better grip.
Using gloves or a dry cloth, remove
the bulb by pulling it straight out.
To replace:
Use a new 120/130-volt halogen
bulb, not to exceed 50 watts.
Replace the bulb with the same type
of bulb that was removed. Your
model will have one of the two types
shown on the left. To determine
the correct replacement bulb, check
the bulb terminals. Bulbs with 2
straight pin terminals are G6.35
bulbs. Bulbs with 2 looped terminals
are G9 bulbs.
(Do not interchange.)
Be sure the replacement bulb is
rated 120 volts or 130 volts (NOT
12 volts).
Using gloves or a dry cloth, remove
the bulb from its packaging. Do not
touch the bulb with bare fingers.
Oil from skin will damage the bulb
and shorten its life.
Push the bulb straight into the
receptacle all the way.
Place the tabs of the glass cover into
the grooves of the socket. Turn the
glass cover clockwise 1/4 turn.
For improved lighting inside the
oven, clean the glass cover
frequently using a wet cloth. This
should be done when the oven is
completely cool.
Reconnect electrical power to
the oven.
G6.35 Bulb
Socket
Tab
Glass cover
Receptacle
Use gloves
or cloth
Receptacle
G9 Bulb
Socket
Tab
Glass cover
Receptacle
(on some models)
(on some models)