GE PACSystems* RX3i, Руководство пользователя

Страница: 22 / 169

Chapter 1. Introduction
GFK-2571N May 2018 11
1.5.1 PNC001 Hardware Implementions (-Ax & -Bxxx)
In January 2018, an updated hardware implementation(-Bxxx) replaced the earlier version (-Ax) of the rack-
mounted PNC001. The following are the differences between these two hardware implementations.
Topic -Ax -Bxxx
Appearance Figure 2 Figure 3
Case Plastic Metal
Attachment to Rack Via plastic case latch and heatsink screw Via two Phillip’s head machine screws
Heatsink Remove plastic knockout from rack No knockout removal required
Status LEDs 6 LEDs 5 LEDs (no USB LED)
LED Behavior See Section 2.8 See Section 2.8
Ethernet Port LEDs 4 singleton LEDs (top of faceplate)
4 banks of LEDs (bottom of faceplate)
The digits representing the port
numbers are backlit by LEDs.
µUSB Port Present Absent
Command Line
Interface
Uses µUSB Port Not available
RJ45 Connector on
Faceplate
Absent Present (Disabled)
Power Requirements Higher (see Section 1.3) Lower (see Section 1.3)
Operating
Temperature Range
0 to 60°C -25 to 60°C
Module Reset Pushbutton “Restart” Membrane “Reset”
With the exception of the Command Line Interface, the -Bxxx version is functionally compatible with the -Ax
version.