GE Multilin D400, Инструкция по эксплуатации

Страница: 33 / 192

CHAPTER 2: INSTALLING THE D400
D400 SUBSTATION GATEWAY INSTRUCTION MANUAL GE INFORMATION 33
Panel mount
If you are using a panel cutout, use the following cutout dimensions:
Figure 7: D400 front panel dimensions
Battery installation
To insert the Lithium
battery
Remove the D400 main module from the chassis and insert the battery in the battery
holder
BT1 . See “Replacing the battery” on page 160 for more information.
Battery removal
J12 - battery backup
enable/disable
The D400 card contains a 3.6V lithium battery to maintain NVRAM contents (processor and
date/time) in the event of a power failure. Move jumper J12 to position 2-3 when storing
board for extended periods. Return jumper J12 to position 1-2 for normal operation.
Table 6 describes the J12 jumper positions and associated functions.
Table 6: Jumper J12 positions
Disconnect the battery if the board is to be stored for extended periods. This conserves the
battery energy.
1.75
in.
[4
4.
46
m
m
]
3.50
in.
[8
8.
90
m
m
]
Cutout for panel mounting
18.3 in. [464.8 mm]
17.5 in. [444.5 mm]
.162 in.
[4.1 mm]
Jumper Position Function
J12 pin 1 to 2 Connects the battery to the NVRAM and date/time
pin 2 to 3 Disconnects the battery from the NVRAM and date/time