GE LOGIQ V3, Базовое руководство по обслуживанию

Страница: 134 / 305

General Procedures and Functional Checks
4-10 LOGIQ V3/V5/V5 Expert – Basic Service Manual
5726264-100 English Rev.8
4-2-4 Check System Date and Time
A warning message "Please check the system date and time are
correct" appears on the screen when the system is powered on.
This warning message appears for the possible reasons:
• The system is not boot up for over 14 days.
• The system time has been changed by 24 hours earlier than
the current system time of last boot-up.
• The BIOS time is changed by 24 hours earlier than the
current system by resetting BIOS time, replacing BIOS
module or changing BIOS time.
This warning message is to remind the user to check the system
date in case the system date and time is incorrect.
Figure 4-2. Check system date and time message
Move the cursor to OK and press Cursor key on the control
panel to select OK. The system enters.
Check the system date and time. If it is incorrect, follow below
steps to reset the system date and time.
• Enter Utility -> System -> General -> Date/Time.
• Reset the system date and time.
• Select Apply and then select OK.
• Select Save.