GE Logiq 500, Руководство пользователя

Страница: 65 / 579

System Positioning/Transporting
LOGIQ 500 Basic Users Manual
2233658–100 Rev. 0
3–14

Transporting the System
Use extra care when transporting the system using vehicles. In
addition to the instructions used when moving the system (refer
to
3–11), do the following:
1. Only use vehicles that are designed for transport of the
LOGIQ

500 system.
2. Load and unload the system to a vehicle parked on a
level surface.
3. Ensure that the transporting vehicle can handle the
weight of the system plus the passengers.
4. Ensure that the load capacity of the lift (a minimum of
180 kg [397 lbs] is recommended) is capable of
handling the weight of the system.
5. Ensure that the lift is in good working order.
6. Secure the system while it is on the lift so that it cannot
roll. Use either wood chocks, restraining straps, or
other similar types of constraints. Do not attempt to
hold it in place by hand.
NOTE: Strap the system below its handle so that the system
does not break loose.
Never ride on the lift with the system. A person’s
weight coupled with the weight of the system may
exceed the load capacity of the lift.
7. Employ two to three persons to load and unload safely
from a vehicle.
8. Load the unit aboard the vehicle carefully and over its
center of gravity. Keep the unit still and upright.
NOTE: Do not lay the unit down.
9. Ensure that the system is firmly secured while inside
the vehicle. Any movement, coupled with the weight of
the system, could cause it to break loose.
10. Secure system with straps or as directed otherwise to
prevent motion during transport.
11. Prevent vibration damage by driving cautiously. Avoid
unpaved roads, excessive speeds, and erratic stops or
starts.
.
WARNING
.