PART
QUANTITY
Trim Frame
1
Bottom Duct
1
Top Bracket
1
Phillips Round-Head
24
Screws (22
required
for installation)
Phillips Flat-Head
5
Screws
(4 required for
installation)
Anti-Tip Bracket
1
Bottom Bracket
1
Template
1
PARTS INCLUDED
Questions? Call GE Answer Center at 800.626.2000
or
Visit our Website at:
www.GEAppliances.com
READ CAREFULLY.
KEEP THESE INSTRUCTIONS
.
Installation
Built-In Trim Kits
Instructions
JX2127 and JX2130
Read these instructions completely and carefully.
•
IMPORTANT –
Save these
instructions for local inspector’s use.
•
IMPORTANT –
Observe all
governing codes and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with the Consumer.
•
Note to Consumer –
Keep these instructions
for future reference.
•
For easier installation and personal safety, we
recommend that two people install this microwave oven.
•
Unplug the microwave oven before attempting
installation of this kit.
BEFORE YOU BEGIN
•
Skill level
– Installation of this appliance requires basic
mechanical and electrical skills.
•
Completion time
– 1-3 hours
•
Proper installation is the responsibility of the installer.
•
Product failure due to improper installation is not
covered under the Warranty.
•
This kit is UL listed for installation alone or over
any General Electric/Hotpoint/RCA single electric
wall oven.
TOOLS YOU WILL NEED
#2 Phillips screwdriver
Pencil
Tape measure
Awl or punch
Drill with
7
⁄
64
″
bit or #35
1
FOR YOUR SAFETY:
WARNING –
Before beginning the
installation, switch power off at service panel and lock
the service disconnecting means to prevent power
from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the
service panel.
Scissors (optional)
