342-86400-498PS
Issue 1.2
April 2012
Page 102
Copyright
GE Multilin Inc. 2010-2012
Rate: In Use
Displays the rate and duplex mode set for this RJ-45 port. The
possible readings are:
-
10M HDX
10Base-T, Half Duplex
-
10M FDX
10Base-T, Full Duplex
-
100M HDX 100Base-TX, Half Duplex
-
100M FDX
100Base-TX, Full Duplex
Note:
When devices on the LAN do not support auto-negotiation and
the ETHER-
1000 unit‟s auto-negotiation is enabled, the unit uses the
highest speed, but in half-duplex mode.
Xover: Allow
Applicable to multi-port paddleboard ports only. May be set to:
Auto
Auto-sensing for MDI/MDIX mode is enabled. The user
can connect to any device regardless of the type of RJ-45
cable used (straight-through or crossover).
MDI
The port is forced to MDI mode
MDIX
The port is forced to MDIX mode
Note
: The "Auto" feature functions regardless of whether the far-end
device is set to “Auto”.
Xover: In Use
For a multi-port paddleboard port, this field may display:
MDI
The port is in MDI mode (auto-sensed or forced)
MDIX
The port is in MDIX mode (auto-sensed or forced)
SFP Status
This frame is active only if the selected port is an optical port on an SFP device.
The information displayed in this frame (see Figure 41) is collected through the
transceiver‟s diagnostic monitoring interface (DMI).
Manufacturer Name
Displays the name of the SFP transceiver‟s manufacturer.
Manufacturer Part# / Revision
Displa
ys the part number that the transceiver‟s manufacturer uses for
this device. The transceiver‟s revision number is also displayed.
Fiber
Displays the type of fiber (smf = single-mode fiber, or mmf = multimode
fiber) that the transceiver shall be used with. Note that smf